Local Reviews
for Shorewood, il
Our Reviews by City
John M.
Found a faulty ejector pump. Replaced with a new, powerful ejector pump. Tested for safe operation. Cleaned the work area
Brad K.
Sewer and drain cleaning. The toilet was backed up and draining into the tub. Lav was draining fine on the opposite side of the run, so the blockage was within 6 feet of the toilet because I was able to open it with an extension on the toilet auger. Cleaned tub after the line was open for customer. Everything is draining as it should be. This was in the hall bath on the first floor
Brad K.
Commercial gas piping repair. Replaced 3/4” stainless gas flexible piping to a tube heater in the service garage. There was a leak coming from the old flex. I used a radius turn when connecting the flex line with no hard turns or kinks recommended by the manufacturer. Turned on the gas, and no more leak. Also, there was a gas leak for the dryer on a fitting coming directly out of the gas regulator. I pulled apart all fittings, re-doped the fittings, taped everything, and installed a new gas 1/2” gas whip for the appliance. Turned on the gas, and no more leaks.
Brad K.
Replaced a sump pump that was not working in the crawl space. Also replaced one hose bib outdoor lawn faucet.
Brennon E.
Air conditioner maintenance. Clean and serviced condensing unit. Tested all mechanical parts. Checked r410a refrigerant charge. Hosed out all sides of condensing coils. The AC system is operating and cooling as it should be at this time. The customer has two more prepaid visits.
John M.
Replaced old 50-gallon water heater with a new energy-efficient model. Tested for safe operation. Cleaned up and removed the old water heater tank.
Chris S.
Replace main sump pump, sent estimate on back up.
Chris S.
Furnace repair. No heat. Diagnosis found a faulty furnace sensor. A furnace flame sensor is a safety device that detects the presence of a flame during combustion, ensuring the gas valve remains open only when a flame is present, preventing potential gas leaks and explosions. Replaced sensor, cycled heating and tested for safe operation. Furnace is 20 plus years old. Will send estimate on new energy efficient furnace.
Michael M.
Washing machine water shut off valves replaced. Water heater maintenance. Drain and flush water heater to remove mineral build up. Water heater is 10 yrs old and never was flushed.
Michael M.
Commercial plumbing service. Urinal not flushing. Delimed urinal on left side in men’s washroom. Backed up instantly with one flush prior. Pulled urinal and calcium deposits were blocking the back outlet side of urinal drain. Cleared with screwdriver. Riddled urinal waste line 20’ out with descaling rudder. Hooked urinal back up and flushes as should now.
John M.
Plumbing repair. Customer was concerned that water was dripping through the strainer before the rpz on the sprinkler system that she doesn’t use, capped off line inside.
Michael M.
Sewer and drain service. Office is installing a drain in an existing slab, and a trap to connect the drain
Brennon E.
Commercial furnace repair. No heat call. System did work when I turned it on. Found the flame sensor was pretty dirty and was reading the flame intermittently when I cycled the furnace a couple times. Changed flame sensor and cycled system a few times and even waiting for second stage heating to engage. System is operating and heating as it should be at this time. Set customers thermostat to 75* via request from her.
John M.
Replaced toilet with American Standard Titan.
Chris S.
Furnace service. Inspected, cleaned tuned furnace, everything is fine. Set thermostat at 75.
Pete W.
Replace shower drain for master bath shower.
Pete W.
Commercial plumbing service. Water filter valve on RO system tank closed. Tested system and is working properly.
Pete W.
Bathroom plumbing repair. Replace basement lavatory faucet with customer supplied faucet. Pull and reset second floor hall toilet.
Chris S.
Boiler repair. Checked room for no heat. Found bad zone valve. Replaced taco zone valve and control power head. The zone valve has two parts. The heat motor which is also called a power head. The other part is the valve body that sits beneath the head. Wired system back and tested for safe operation.
John M.
Sump pump repair. Backup pump alarm was going off upon arrival saying that the pump was activated. Reset alarm and pulled lid. Found primary pump to be working fine and is less than a year old. Best guess is that with the amount of rainfall this morning the primary pump couldn’t keep up.
Brennon E.
Furnace repair. No heat call. I cleaned and serviced furnace due to annual maintenance plan. Customer had not changed his filter in about a year he claimed. Filter was black, causing system to over heat. Changed furnace filter that customer provided. (20x25x4). Changed humidifier pad that customer provided.(35). Cleaned all sensors and exhaust pipe. System is operating and heating as it should be at this time. First visit one plan, customer will have one more visit on maintenance program for this 2025 cooling season.
Pete W.
Toilet repair. Pulled and reset toilet in master bath.
Brennon E.
Cleaned and serviced furnace. Tested all mechanical parts. Everything is in accurate working condition. Customer renewed maintenance program. Will have both visits prepaid. Replaced humidifier pad. (10). System is operating and heating as it should be at this time.
Brennon E.
Cleaned and serviced furnace due to last visit on maintenance program. Cycled and tested all mechanical parts. Replaced furnace filter that customer provided. (410). Cleaned drain trap and all hoses. Leaned all sensors. System is operating and heating as it should be at this time. Customer renewed maintenance program. They will have 2025 spring cooling season visit and 2025/2026 heating visit prepaid. Performed free inspections.
Chris S.
Replaced humidifier water panel and tested, will also send estimate for bathroom remodel.
